LCP(R) - Landing Craft Personnel - Ramp
- Description
- Reviews
- Files
Waterline-model of the LCP(R).
A personnel carrier similar to the LCP(L), with an added ramp to decrease debarkation time. It could carry up to 30 fully equipped troops.
The model has been prepared and detailed for 1:100 and 28mm war-gaming. It is waterline model and not a complete hull design. The Hull would be below water and would not work on a gaming table.
Test printed using PLA on a Creality Ender 5 (upgraded to pro), 020mm layer, photo's of the test-prints included. Resin prints are from an Anycubic Mono SE 005mm layer, standard Resin. Support files for Resin printing (1:100 scale) are included, these work fine for me. Feel free to use, but might be best to create your own supported files tuned to your own printer.
A model with some extra internal support is also included, this can be used for FDM-printing. No support required if you print the model flat on the printer-bed.
Model dimensions when printed in 1:100 scale
~ 11,5 cm long (Ramp closed)
~ 3,5 cm wide
~ 1,5 cm high
For 28mm re-scale to 178,57%.
Copyright Allan Smit 2026
Non Commercial and personal use only. May not be shared, uploaded or otherwise distributed.
A personnel carrier similar to the LCP(L), with an added ramp to decrease debarkation time. It could carry up to 30 fully equipped troops.
The model has been prepared and detailed for 1:100 and 28mm war-gaming. It is waterline model and not a complete hull design. The Hull would be below water and would not work on a gaming table.
Test printed using PLA on a Creality Ender 5 (upgraded to pro), 020mm layer, photo's of the test-prints included. Resin prints are from an Anycubic Mono SE 005mm layer, standard Resin. Support files for Resin printing (1:100 scale) are included, these work fine for me. Feel free to use, but might be best to create your own supported files tuned to your own printer.
A model with some extra internal support is also included, this can be used for FDM-printing. No support required if you print the model flat on the printer-bed.
Model dimensions when printed in 1:100 scale
~ 11,5 cm long (Ramp closed)
~ 3,5 cm wide
~ 1,5 cm high
For 28mm re-scale to 178,57%.
Copyright Allan Smit 2026
Non Commercial and personal use only. May not be shared, uploaded or otherwise distributed.
No one's reviewed this product yet. Let people know if you enjoyed this model!
| Filename | Size | Last updated |
|---|---|---|
| LCP-Ramp-Wargaming3d.zip | 27.6 MiB | 2026-01-23 |
