Mp40 Variants 1/35
Developed in Nazi Germany and used extensively by the Axis powers during World War II.The MP 40's variants included the MP 40/I and the MP 41 which was, in reality, an MP 40 upper receiver with a lower receiver of an MP 28/II submachine gun. It saw limited service, however, and was issued only to SS and police units in 1944. The MP 41 was also supplied to Germany's Axis ally Romania.
The set contains 3 detailed models for each scale, two mp40’s with extended and folded stock and a very rare mp41 with wooden stock.
If you are going to print the models with supports included, it is important to have the correct exposure time. In case the models are not generated or are stuck to the fep, it is necessary to increase the exposure time. On the contrary, it is also common for models to be generated but these are overexposed. you can tell this because sometimes the uprights are fused to the figure. The exposure time varies depending on the resin, sometimes I set it to 2.5, other times to 4.5s
When removing the supports, I recommend using hot water to soften them. In case you have problems with printing, let me know at [email protected]
The set contains 3 detailed models for each scale, two mp40’s with extended and folded stock and a very rare mp41 with wooden stock.
If you are going to print the models with supports included, it is important to have the correct exposure time. In case the models are not generated or are stuck to the fep, it is necessary to increase the exposure time. On the contrary, it is also common for models to be generated but these are overexposed. you can tell this because sometimes the uprights are fused to the figure. The exposure time varies depending on the resin, sometimes I set it to 2.5, other times to 4.5s
When removing the supports, I recommend using hot water to soften them. In case you have problems with printing, let me know at [email protected]
| Filename | Size | Last updated |
|---|---|---|
| Mp40 Variants (1-72,1-35).zip | 256.3 MiB | 2024-11-24 |
