1:100 Ural 4320 ATZ-5
Up next in my line of Ural 4320 variants is the ATZ-5 which is a truck used to refuel a wide range of things that need... well, to be refueled.
If I am reading it right, this truck held approximately 10,000 litres of fuel and could empty the tank in 25 minutes with the assistance of an onboard pump. The Ural 4320 6x6 is a hardy and quite versatile vehicle used by many nations and still in service around the world to this date.
Update 4-17-23: I noticed a problem with the original chassis for the truck and have uploaded version two now which also has more detail and the proper tires on the truck.
Printing Destructions:
I have not broken this model at all and it should easily fit onto most any resin print bed. If I get a chance I will start working on including some pre-supported models as well since I fully plan to print these out for myself also.
Aside from that, on printers like Elegoo Mars and Anycubic Photon, if you rotate the model 60 degrees with the end down, just add your supports and print away.
For resin I prefer to use Siraya Tech Simple Clear mixed with Tenacious. I use 75-80 Simple to 20-25% Tenacious. This has not given me any problems since I started this mix and the only time I get failures now is when I am experimenting with things or forget to do my supports right.
If I am reading it right, this truck held approximately 10,000 litres of fuel and could empty the tank in 25 minutes with the assistance of an onboard pump. The Ural 4320 6x6 is a hardy and quite versatile vehicle used by many nations and still in service around the world to this date.
Update 4-17-23: I noticed a problem with the original chassis for the truck and have uploaded version two now which also has more detail and the proper tires on the truck.
Printing Destructions:
I have not broken this model at all and it should easily fit onto most any resin print bed. If I get a chance I will start working on including some pre-supported models as well since I fully plan to print these out for myself also.
Aside from that, on printers like Elegoo Mars and Anycubic Photon, if you rotate the model 60 degrees with the end down, just add your supports and print away.
For resin I prefer to use Siraya Tech Simple Clear mixed with Tenacious. I use 75-80 Simple to 20-25% Tenacious. This has not given me any problems since I started this mix and the only time I get failures now is when I am experimenting with things or forget to do my supports right.
| Filename | Size | Last updated |
|---|---|---|
| Ural 4320 - ATZ5 Fuel Tanker-1.stl | 17.8 MiB | 2024-02-28 |
| Ural 4320 - ATZ5 Fuel Tanker.zip | 6.0 MiB | 2024-02-28 |
