Australian Dozer Matilda Mark I Tank

Australian Dozer Matilda Mark I Tank in 1/72 scale as a scale model or main part of your diorama, with high amount of details.

What's included:
- Hull - two options - with or without open hatch
- Turret - two options - with or without open hatches
- Gun
- Dozer Blade
- Pins to secure dozer with hull - if you want the dozer blade to move up and down then only glue the pins to the hull
- Hydraulic parts - do not use glue if you want the doze blade to move, only secure it with top pin
Pin locations shown in images section

Note - printed design in picture is assembled but not glued together. Images of printed design are in 1/72 scale. Tolerances are quite small, might require use of a drill bit to make holes for pins slightly larger but this will depend on printer settings and capability of 3D printer you use.


Requires a resin printer due to the amount of small details.
Unsupported and pre-supported version available, if you wish to adjust supports or add your own then please do so.
I use Chitubox slicer software and it does it automatically without any issues. highly recommended to put these at an angle of around 20deg

Printed successfully in 1/72 scale on 0.025mm and 0.05mm layer height on a resin printer.