Deweycat CG-4 Waco / Hadrian Glider - 28 mm scale
There are two folders, each with 11 parts; one in scale 1/64th scale (as in photos) and one in 1/56th scale
Please clean and test fit all parts, post print, prior gluing. I recommend assembling the tail section to the main fuselage section, and then securing the wings, with overlap at the fuselage. Do ensure the winds remain level as the adhesive dries. I this with a plastic clamp, but even held in hand will work. Once that is set, add the wing struts. Once that is dry, all the landing skids and then the landing gear.
The nose section has two mounting options
In FDM, print with supports. These models were printed at .2mm; it is a large model, and you won't miss much detail at .2mm, but I would not recommend printing at a coarser thickness.
Please clean and test fit all parts, post print, prior gluing. I recommend assembling the tail section to the main fuselage section, and then securing the wings, with overlap at the fuselage. Do ensure the winds remain level as the adhesive dries. I this with a plastic clamp, but even held in hand will work. Once that is set, add the wing struts. Once that is dry, all the landing skids and then the landing gear.
The nose section has two mounting options
- For the closed version, there is a mounting sleeve that slides into the nose and then into the fuselage opening.
- For the open nose version, there is an "L" shaped mounting bracket that is glued to the top inner edge of the nose cabin and once that is dry, it is glued to the top of the fuselage opening. Always test fit before gluing.
In FDM, print with supports. These models were printed at .2mm; it is a large model, and you won't miss much detail at .2mm, but I would not recommend printing at a coarser thickness.
** If you have any questions or concerns, please contact me directly at [email protected] **
| Filename | Size | Last updated |
|---|---|---|
| CG-4 Waco-Hadrian glider stl pack-2.zip | 1.8 MiB | 2024-02-28 |
