Deweycat El Alamein Railway Station - 28mm updated 2023
This file produces a print that is 215mm in length (both the base and the roof sections). It should fit the build plate of most common FDM printers.
The print consists of the building itself (with the integral base), a two part roof, and two signs; the actual "Alamein" sign and a generic sign which you can use to use the station for any other locale.
I would suggest printing at .25mm settings, with supports - supports are required due to the arch ways and fitting recesses.
I find assembling the roof is best completed by hand fitting the roof pieces to the building, placing a dab of CA glue on the very ends of the roof panels (so they are at the correct 25 degree slope abutting the building peak), hold that until it sets, and then removing the roof and run a stream of glue along the roof seam.
The print consists of the building itself (with the integral base), a two part roof, and two signs; the actual "Alamein" sign and a generic sign which you can use to use the station for any other locale.
I would suggest printing at .25mm settings, with supports - supports are required due to the arch ways and fitting recesses.
I find assembling the roof is best completed by hand fitting the roof pieces to the building, placing a dab of CA glue on the very ends of the roof panels (so they are at the correct 25 degree slope abutting the building peak), hold that until it sets, and then removing the roof and run a stream of glue along the roof seam.
| Filename | Size | Last updated |
|---|---|---|
| El Alamein Train Station .stl pack - updated 2023-1.zip | 6.3 MiB | 2024-06-21 |
