Sd.Kfz. 250/1 AusF A

The Sd.Kfz. 250/1 was German halftrack used to transport infantry during World War 2. The vehicle was visually similar to the well-known Sd.Kfz. 251/1, however it was considerably smaller with a lower transport capacity.

In Armored Advance:
The 250/1 serves as a light infantry transport for the axis, having less transport capacity than the 251/1, it is still able to bring infantry around the board quickly and has a machinegun mounted, permitting some level of anti-infantry capabilities. The vehicle benefits over the 251 in having more health relative to its cost, while also possessing the same offensive capabilities. However, as a transport you will get more "bang for your buck" with a 251.

3D printing settings:
Dimensions:
Length - 2.47" (62.7mm)
Width - 1.06" (27mm)
Height - 0.87" (22.1mm)
Estimated Print Time - 3 hours

This model comes pre-supported and ready to print in 1/72 scale. Unsupported files are also included, allowing you to adjust the scale to your preference. This model is designed with resin printing in mind and is not optimized, nor tested for traditional FDM (filament) printers. The model was test printed successfully several times on an ANYCUBIC Photon Mono 4K resin printer. If you have any issues with the file, don't hesitate to reach out to me at [email protected]