Deweycat Wall System .stl pack for table top gaming

A short while after the release of the Deweycat Middle East Terrain packs, a purchaser (and local Bolt Action player) asked if I could do a set of walls for that pack. Wade explained that with the changes in version 3, having more cover on the table is desirable for a game that was more than sitting in your deployment zone and shooting for six turns.

I did up this set and kept it simple. I do not design stls for dioramas, but for gamers. I skipped any fussy interlocking mechanism, instead having each piece being able to butt tightly to any other, to create a visually seamless wall system.

Although this set is painted to fit a Middle East themed table, by painting it in grey tones, it would work equally well in an European, industrial themed terrain.

The set consists of the basic wall section, four different damaged wall sections, each allowing an entrance / firing position, a gated section, with gates both for FDM printing (detailed only one side), and a resin printing (with both sides finely detailed). Finally, there are three different half sections.

The long wall sections are 113mm long, and approx. 40mm high, but can be scaled up or down as required for your needs.

All stls can be printed in FDM without supports.

These are suitable for both resin and FDM printing. The models in the pictured test prints were all FDM prints.

There are files included for both FDM and resin printing

FDM printing without supports should be doable for FDM printing.

Please note the pre-supported files for gate doors may not be ideal for your printer, resin, or settings. They are provided as a courtesy only, and while they worked well for me, your results may vary.