Chateau D’If
This is my attempt at a 1-1200 model of my all time favourite Mediterranean prison/fortress island - Chateau D’If
My painted example was printed on a Prusa I3 Mk3 with a 0.4mm nozzle and a 0.2mm layer height.
The models dimensions are 217 x 135 x 25mm (included is a version split into two pieces for smaller printers)
I prime the model then apply watered down PVA glue to the areas that are terrain. I sprinkle very fine sand onto the PVA. When this has dried I paint over the sand with a mixture of watered down paint and PVA Glue. When this is dry I do a drybrush over the sand. I paint watered down PVA glue in the areas i want to be covered in grass then sprinkle on flock. The tress are "clump foliage" glued down with non-watered down PVA glue.
My painted example was printed on a Prusa I3 Mk3 with a 0.4mm nozzle and a 0.2mm layer height.
The models dimensions are 217 x 135 x 25mm (included is a version split into two pieces for smaller printers)
I prime the model then apply watered down PVA glue to the areas that are terrain. I sprinkle very fine sand onto the PVA. When this has dried I paint over the sand with a mixture of watered down paint and PVA Glue. When this is dry I do a drybrush over the sand. I paint watered down PVA glue in the areas i want to be covered in grass then sprinkle on flock. The tress are "clump foliage" glued down with non-watered down PVA glue.
| Filename | Size | Last updated |
|---|---|---|
| CHATEAU-DIF.zip | 4.8 MiB | 2024-02-28 |
| Dif-cut-in-half-for-smaller-printers.zip | 5.2 MiB | 2024-02-28 |
