German Opel Blitz Fuel Tanker WWII (Advanced Version) Intended to be printed in PLA but with fine detailed parts done in Resin. I have personally printed this model in resin as well. You will need to consider how you orientate parts and where you place the supports.
The models consists of the following files:
Main cab/chassis
Front Wheel
Rear Double Wheel
Locker section nearest to the cab
Support mount for the Fuel Bowser
Fuel Bowser
Top hatch to close bowser
Rear Locker hold the pumping gear
Coiled Fuel Hose
At 1/56 scale the model is approximately 109mm long, 38mm wide and 46mm high. Models in the attached photos were printed at a 0.1mm layer height and a speed of 40 on an Ender 3
Photos of the painted vehicle do include so parts from the advanced kit.
This advanced model includes:
Section A (just behind the cab) has stowage draws revealed.
Section A doors.
Section A stowage draws with a selection of equipment.
Sections B&C merged for resin printing.
Section D an open void to receive the pumping gear.
Section D Pumping gear on a flat base to slid into the main open body of D
Section D Rear Doors left and right.
Section E Hatch to the fuel tank (E1) and the option to have the Hatch Open (E2+E3)
Exterior Access Ladder.
I have included the Basic Version STLs as well
This model was designed by Neal Bowskill copyright July 2020; printed versions of this model have been available since this date on Ebay and has appealed to those who like niche models.
Reviews
There are no reviews yet.